210 FSH Delux Garage fitment

[tweeter1148]

Hello everyone...I am looking for a measurement for height of the 210 Delux model without the tower. I have a three car garage so I think but the boat in at an angle and get it to fit but I am concerned about the height. Can anyone help me out?
Thanks,
Brandon

 

[Foobar]

Standing next to my boat washing it today, it seemed about 5'6" to the top of the gunnel at the highest point. The windshield is probably 2' to 3' higher than that. So, about 8'5" ? Maybe 8' ? Worst case scenario you can remove the windshield. It comes off easily with finger latches.

 

[tweeter1148]

So do you think it is under 7' without the windshield?

 

[Hector Leiva]

Hello everyone...I am looking for a measurement for height of the 210 Delux model without the tower. I have a three car garage so I think but the boat in at an angle and get it to fit but I am concerned about the height. Can anyone help me out?
Thanks,
Brandon

Own a 190 FSH Deluxe not a 210. However, I have looked at a handful of the 210 at the dealer and they do not appear to be any taller. If my assumption is correct it would be no different than a 190 and the windshield and seat back would have to be removed if the garage door opening height is less than 8’. Removing the windshield is no issue, but removing the seat back is more time consuming. I would estmate 10-15 minutes to remove both and the same amount of time to replace. When I was storing my 190 in my garage I just kept the seat back permanently off. I think most people would agree they rarely use the seat back.

 

[Frank Marshall]

IMG_20171128_133719087

• Frank Marshall
• Nov 29, 2017

I was able to get it into my garage (7'-4"), but I had to increase the garage door rise to accommodate the seat cushion. There's a 3" gap at the base of the door when it's closed.
It does go straight in @ 22'. Not any room for cars though.

 

[Foobar]

So do you think it is under 7' without the windshield?

I will measure it later today when I work on the boat.

 

[tweeter1148]

Thanks everyone this definitely helps!

 

[vesder21]

same question, but didn't see a final published number. what's the total length of the 210 on a trailer? i'm considering purchasing one to run on lake erie and would like to garage if possible.

thanks!

 

[Hector Leiva]

If your garage is level and you are able to push it physically or mechanically you can lower the front of the trailer and lower the tire inflation. Hope this helps.

 

[Frank Marshall]

I measured mine at 267-1/4" to electrical wire sticking out with the tongue folded back.
289-1/4" with the tongue extended.
Keep in mind that I moved the bow roller as far forward as possible, and then moved the axles forward to keep the tongue at 7% of total weight, boat as equipped plus trailer weight.

 

[vesder21]

thanks for the measurements!!!

 

[Julian]

Yamaha lists the FSH DLX as 102" for height on trailer. Length on trailer tongue folded is 22'

 

[vesder21]

the height should be fine if i remove the top, but it's the length. i have a 3 car garage and was hoping to only use up the double port, but i may need to just park it in diagonally and use up the 3rd port.