After market <air> Intake tubes..

[Ratket]

So this winter I want to remove the stock cumbersome air box and intake tubes.
What are the options for aftermarket intake tubes? I will likely do a ribbon delete as well. I’m not worried about the filter as I can measure and order a good filter from just about anywhere with an outerwears wicker bag or some type of water repellent. If anyone has done this and has part numbers, it would be greatly appreciated. Thanks for any and all replies.

Boat is a 2014 212x.

 

[jEt_jAk]

I just did it recently with these 2 parts:

K&N Universal Clamp-On Engine Air... https://www.amazon.com/dp/B00AFRIVNQ?ref=ppx_pop_mob_ap_share

HPS AJ400-300 6061 T6 Aluminum... https://www.amazon.com/dp/B014GXPWV8?ref=ppx_pop_mob_ap_share

 

[Ratket]

I just did it recently with these 2 parts:

K&N Universal Clamp-On Engine Air... https://www.amazon.com/dp/B00AFRIVNQ?ref=ppx_pop_mob_ap_share

HPS AJ400-300 6061 T6 Aluminum... https://www.amazon.com/dp/B014GXPWV8?ref=ppx_pop_mob_ap_share

Your intake is different than mine. I am assuming you used the aluminum spacer to bridge the gap between the intake tube and the intake manifold?

 

[jEt_jAk]

I am using the stock tube and used the spacer to attach the filter. Tight fit but seemed to work ok. I also used a steel cable tie to give it a bit more support.

 

[TJP027]

So this winter I want to remove the stock cumbersome air box and intake tubes.
What are the options for aftermarket intake tubes? I will likely do a ribbon delete as well. I’m not worried about the filter as I can measure and order a good filter from just about anywhere with an outerwears wicker bag or some type of water repellent. If anyone has done this and has part numbers, it would be greatly appreciated. Thanks for any and all replies.

Boat is a 2014 212x.

Hey, just found this post today.

I have a 2016 212x, did you make anything happen?