cane.mba
Jetboaters Commander
- Messages
- 689
- Reaction score
- 350
- Points
- 197
- Location
- Nashville, Tn
- Boat Make
- Yamaha
- Year
- 2012
- Boat Model
- Limited S
- Boat Length
- 24
Ok, so I've been dreading the fact my boat has been sitting in the water since early April. Even though I spent a week detailing every inch, and applied Rejex to the hull for the first time. I've been very impressed with Rejex so far on the upper hull, and my truck. Ok, before I get ahead of myself..
We usually pull the boat out 3 or 4 times a season to gas it up, clean the hull, and a good thorough cleaning. Those cookie, cracker, and chip crumbs can sink a boat over time! Well the lake has dropped a couple of feet (thank you Army Corps of Engineers), so I pulled her out this morning. I wanted to use my new boat brush at the ramp to knock all the heavy growth off, but my boys were having none of it, so ten minutes after leaving the water she was home and in the driveway. 15 minutes later one side had been sprayed down with Atwood Biodegradable Hull Cleaner. While it sat for the few minutes suggested, I got the pressure washer ready. After I had pressure washed an area, my wife came behind and used the brush to make sure we had gotten as much as possible. Then Rinse repeat the other half of the hull and the aft swim fleck area was last.
Before
I'll post the after pics in a few minutes. My Hurricanes are playing and my phone with the after pics is upstairs....
We usually pull the boat out 3 or 4 times a season to gas it up, clean the hull, and a good thorough cleaning. Those cookie, cracker, and chip crumbs can sink a boat over time! Well the lake has dropped a couple of feet (thank you Army Corps of Engineers), so I pulled her out this morning. I wanted to use my new boat brush at the ramp to knock all the heavy growth off, but my boys were having none of it, so ten minutes after leaving the water she was home and in the driveway. 15 minutes later one side had been sprayed down with Atwood Biodegradable Hull Cleaner. While it sat for the few minutes suggested, I got the pressure washer ready. After I had pressure washed an area, my wife came behind and used the brush to make sure we had gotten as much as possible. Then Rinse repeat the other half of the hull and the aft swim fleck area was last.
Before
I'll post the after pics in a few minutes. My Hurricanes are playing and my phone with the after pics is upstairs....