Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

Click Here for more information>Ride Steady group buy for JetBoaters.net members only

You can dismiss this Notice by clicking the "X" in the upper right>>>>>

General Discussion

AT309 install

Thread starter Fordjet
Start date May 9, 2021

Fordjet

Member

May 9, 2021

I have a new river boat I have purchased, I pulled it out of the water for the first time and was looking at the AT 309 installation. The tiller or steering arm has been cut and the tip ground off and new mounting hole drilled, just wondering if anyone has done this or seen this done, it’s a little disappointing as it is a new boat, also wondering if this install would affect the overall steering as it seems like it has. Attached pictures