• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter

Attempting to adjust Bimini Height on 2020 242 XE, but the M10 width of the Knob's screw does not fit the M8 threaded hole on the L-Shape Connector.

Vazquecj

Vazquecj

Member
Messages
1
Reaction score
0
Points
10
Location
Ft Lauderdale
Boat Make
Yamaha
Year
2020
Boat Model
242X E-Series
Boat Length
24
Hi all! I need to adjust the height of the Bimini, however the thread of 'L-Shaped Stay' (as it's named in the attached image from the manual) is not compatible with the thread of the Locking knob. The bolt on the locking knob is an M10 with only 1.27cm protrusion, while the internal thread on the L-Shaped Stay is M8 and the thread doesn't begin until approximately 1.905cm up, so it doesn't reach. Does anyone know of a solution for this? perhaps an adapter, coupler, or changing out of the threaded locking knob to one with an M8 bolt? I'm leaning in that direction, but am unsure of how to remove the locking knob.
 

Attachments

  • Manual and issue.jpg
    Manual and issue.jpg
    292.2 KB · Views: 11
  • M10 female connection on L.jpg
    M10 female connection on L.jpg
    278.8 KB · Views: 12
  • schematics of L Shape.jpg
    schematics of L Shape.jpg
    449.5 KB · Views: 9
You must log in or register to reply here.
Back
Top