Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

Click Here for more information>Ride Steady group buy for JetBoaters.net members only

You can dismiss this Notice by clicking the "X" in the upper right>>>>>

General Discussion

Cooling Discharge Port

Thread starter Wesley Cobb
Start date Aug 3, 2020

Wesley Cobb

Jet Boat Addict

Aug 3, 2020

During a recent over-exuberant wash, I broke one of the cooling discharge ports off the hull. I am talking about the little gray, angled ports on the starboard side next to the bilge port. Has anyone replaced them and if so, how difficult was it? It seems it can be removed after unscrewing the retaining ring but, I didn't want to attempt removal until I knew how the little port was attached. Any advice would be appreciated. Wanted to post a picture but neglected to get one this weekend.

You must log in or register to reply here.