Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

Click Here for more information>Ride Steady group buy for JetBoaters.net members only

You can dismiss this Notice by clicking the "X" in the upper right>>>>>

Fuel Gauge Wiring

Thread starter dordelli
Start date May 22, 2016

dordelli

Jet Boat Junkie

May 22, 2016

Need to replace the Fuel Gauge in my LX210, got a Faria gauge that matches the stock closely, it was only one I could find with a brushed silver grey bezel. The problem in wiring this new gauge is the stock 3 pin pigtail is too small to mount, the male prongs are bigger than on the stock gauge, is the solution to remove the pigtail and hardwire them directly to the prongs? Can't find any other gas gauges that list different size plug/posts, so it seems the only route?

You must log in or register to reply here.