intermediate bearing

[rickd01]

Anyone have a pic of where this is on a 2013 AR240. I cant seem to find

 

[Murf'n'surf]

It's directly aft of the motor. It's has a plastic shield over it and a grease nipple. #4 in the Propulsion - Internal chart below

http://partsfinder.onlinemicrofiche.com/riva_normal/showmodel.asp?Type=14&make=yamahajb&a=9&b=28#

 

[rickd01]

thanks Murf

 

[dan144k]

Be careful not to overfill it with grease. Search and read several posts about it.

 

[0627Devildog]

Be careful not to overfill it with grease. Search and read several posts about it.

Yes this can EASILY be over done. The smaller the grease gun, the better. Resistance in the pump handle is more easily felt with a smaller grease gun. Once you feel the resistance build up relative to the first few pumps, proceed with extreme caution. It is all feel.

 

[GTBRMC]

It's directly aft of the motor. It's has a plastic shield over it and a grease nipple. #4 in chart below

http://partsfinder.onlinemicrofiche.com/riva_normal/showmodel.asp?Type=13&make=yamahajb&a=9&b=28&c=0&d=2013 AR240 HIGH OUTPUT PROPULSION SYSTEM - EXTERNAL

@Murf'n'surf - maybe I did something wrong, but please check your reference -- when I clicked on your link it took me to this Riva exploded diagram, where #4 is a mounting bolt & washer:

 

[Murf'n'surf]

My bad! Link corrected, I can't get the proper link to show while on my phone. So, follow the link and look at the internal propulsion diagram.