Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to Jetboaters.net!
We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!
Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.
I don't see a problem with using a larger gauge wire than necessary for the LED wiring, perhaps up to 16-gauge for the long runs. But I would have a concern with a thick & heavy wire directly connected to the unrestrained leads coming off most delicate LED fixtures or strips. Weight times the shock and vibration as more of a physical issue rather than an electrical one. So as long as you tie-up the wires and use a smaller gauge as an extension from the junction to the fixture/strip, I see no problem.
I think it's 18 gauge wire. It's the wire that came with marine speakers I bought that I didn't use. The LEDs are speaker rings and the wire coming off is about the same size as the speaker wire. I can secure it well enough that it wont pull on the attached wires to the ring.
My bigger concern was whether their is a difference between speaker wire and electrical wire. I know it sounds crazy, but if its all the same, why not buy an extension cord and use it to wire up speakers?
It is essentially the same wire, especially for the LED purposes.
Some speaker wire is "Oxygen free copper" and then you can get into twisted, cryogenic treated and other stuff (depending on how much that you want to spend).
And for the record, I connected my house speakers with white lamp cord because it matched better than the clear/copper jacketed speaker wire.
For low voltage any wire will do, but when you start running AC the wire and jacket makes a huge difference. 18 gauge will attach easily to your LED lights. I was worried you had a monster gauge speaker wire and trying to connect it to a little 18 gauge would have been silly. Another part of using wires designated for AC or DC properly is identification down the road. If you saw an orange extension cord running through your garage you would automatically think its AC and not speaker wire. Safety is the issue.
Yes I hooked up the led speaker rings on the transom speakers. I installed an underwater Abyss light that came with a relay which is on its own battery connection and switch. The way I have it set up is when the underwater Abyss is turned on the speaker ring lights come on.