Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

General Discussion

Removing throttle panel

Thread starter MaineLakeJetDude
Start date Aug 9, 2024

MaineLakeJetDude

Member

Aug 9, 2024

Hi posted this in Chap thread but thought I would ask general thread. I am trying to remove the panel behind my throttle and have removed all of the screws I see including the plate holding the throttle. Now the panel seems still tightly in place. I don’t want to break anything but should I just ply it off as it’s likely held in with anchors?

I have a Chap Vortex 2019 203 VRX but assume there is a general way that panels are held in place in boats including Chaps.

Also, any advice in how to get to wiring on the Port “glovebox” side? I think I need to replace a fuse in there

Thanks for any advice.

You must log in or register to reply here.