Robertson Square 4 bit, and torque specs

[PaulyB]

Does anyone nearby Virginia have any of the Robertson Square #4 bits to pull the gas tank cover up?

Also does anyone know the torque specs on the engine mount bolts from the engine block into the rubber mount? I pulled some engines and am trying to out them back in properly. Also any advice on where to place the spacers or how to find out if it needs spacers under the mount?


Thanks!

 

[zipper]

Does anyone nearby Virginia have any of the Robertson Square #4 bits to pull the gas tank cover up?
Thanks!

Bought mine here https://www.lawsonproducts.com/Falcon-Tools/ScrewdriverInsert-Bit-Robertson-Square-Drive-4/FA5515.lp

 

[Scottintexas]

do you have a service manual, I think it lists installation/alignment details,

 

[PaulyB]

I don't have have service manual.... maybe someone on here does?

Thanks

 

[zipper]

I had an electronic service manual, I got on the other site, for my 07 ar 230 on a mac that crashed. Cannot retrieve. All I can locate is this from an 04 sr 230. Do not know if it has changed since. Probably has for HO.

Edit: the mount torque specs are the same as in the 07-09 manual

Top of page.

 

[Andy S]

I have 4 #4 Robertson bits and a service manual I would sell you, pm of you are interested.

 

[zipper]

@PaulyB Those numbers I posted earlier are the same as listed in the 07-09 service manual.

But You probably already know this, because you might have the manual already.