Austin1
Active Member
- Messages
- 21
- Reaction score
- 4
- Points
- 42
- Boat Make
- Yamaha
- Year
- 2009
- Boat Model
- SX
- Boat Length
- 21
So I took my 2009 SX210 out on the water today for the 3rd time since buying it used from the dealer. I notice as soon as I am leaving the ramp that the port engine rpms slightly jumping around on tach vs the starboard engine rpms steady in one place. I then also notice the check engine light on the port engine gauges. I figure the hiccup could just be some bad fuel so I open it up and the boat runs completely fine. I immediately decide to turn around and head back to shore to be safe because of the check engine light and now the port engine will not go over 6k rpms. It just stops there. While loading the boat I noticed that cooling water was only exiting from one of the two nozzles. Not sure if that is relevant or not. Anybody have any clue what it could be? Its under warranty but the dealer is weeks out and over an hour drive away.