Thrust vectors ??

[2019scott195wake300]

Ok guys I ordered the vectors and went to mount it tonight and I came across a problem. Looks like the bottom bracket is to short. I watched the video of how to install and read the instructions a few times. Even says to use red lock tight but blue is in my kit. It is also seated croccet to the nozzle so im out of room. I know I can make it work with a few modifications but just want to know if I'm missing anything???

 

[Jet Boat Tom]

Just installed these on my Glastron jet. Looks like the bottom is not seated in all the way? Mine also came with Blue Loctite. I would loosen the top and try to get the bottom to seat into that notch better.

 

[2019scott195wake300]

ill try that again at lunch. it looks like the nozzle is seated flush inside the ring though. ill see if i get get some pics at lunch..

thanks again for the help

 

[2019scott195wake300]

This pic shows more of what's going on. You can see where the bracket isn't long enough to sit down behind the vector

 

[Coltman45]

I installed them on mine, the gap closed when I put the vectors on! Be careful my thrust vectors were ruined after second use, some outstanding human came by with a huge wake and slammed the boat off the bottom. Just be careful

 

[Dean P]

I installed them on mine, the gap closed when I put the vectors on! Be careful my thrust vectors were ruined after second use, some outstanding human came by with a huge wake and slammed the boat off the bottom. Just be careful

I had them too as mine bent for the same reason. Switched to the Cobras and never had a problem again.