Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

Torque spec for ladder bolts

Thread starter Osric
Start date Jul 10, 2019

Osric

Jet Boat Addict

Jul 10, 2019

The swim ladder is held in place by four bolts that go into the underside of the swim platform. Since I don't have easy access to a trailer or work area for installing my wake wedge, I was trying to figure out the torque spec and had a draft posting asking about it before I finally managed to buy the e-book version of the service manual.

The swim ladder on the 242x E-Series is held up by 4 M8 x 35mm bolts and sealed with ThreeBond 1344N, tightened to 17nm. This is a specific torque spec for these bolts and is different than the generic torque spec for M8 bolts on the boat.

Osric

You must log in or register to reply here.