Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

Click Here for more information>Ride Steady group buy for JetBoaters.net members only

You can dismiss this Notice by clicking the "X" in the upper right>>>>>

Wear ring orientation

Thread starter Bluejuice
Start date Jun 7, 2019

Bluejuice

Jet Boat Addict

Jun 7, 2019

So I ordered new wear rings for my 03 sr230. For housing 003-508. Googled replacement plastic wear ring for 003-508 and got sent a 003-522. More research shows that this should be right. If I slide the wear ring over the impellar there is excessive play. Do the plastic liners compress when installed in the housing? I dont want to remove the old one without knowing for sure.

Also, I'm not home at the moment, but is there a specific orientation for installation? How do I figure out which side goes in the housing?

Been googling all day with no help.

Thanks in advance if you can help.

-Roy

You must log in or register to reply here.