New 252SE - bunk measurements for lift

[kmcenaney]

I will pick up my 2025 252SE next week and need to upgrade my boat lift for the longer length and heavier weight (previous boat is a 2011 Moomba 21 ft v-drive). I am in the process I want to make sure I have the right spacing for my bunks and particularly be sure I have clearance for the keel to avoid any contact with the cross bar. I have done some searching and I could not find any hull/keel measurements from Yamaha. Thanks for any advice.

 

[Hot2Go]

I can try to get into storage sometime soon and measure the boat on the trailer at multiple points. Won’t be able to until Monday though!

 

[Hot2Go]

I don’t know if this will help but this is the best I could do.. Boat does look aligned on the trailer properly so not sure why the sides are off by a bit but oh well, must be from the shorelander factory. Which may be someone you call to ask about bunk placement on a lift?

Rear outside bunk measurement from keel to side of the board closest the keel. The outside board is approximately 6’ long.




Below are measurements for the front of the outside bunk stbd side and then rear of the middle bunk on stbd side.

Measurements for port side are:
Rear of middle bunk 10in
Front of outside bunk 17in


Inside bunk is approximately 8’ in length. Front of inside bunk port 10in and stbd 9.5in:


Not sure if this helps you in any way but good luck!

 

[kmcenaney]

I don’t know if this will help but this is the best I could do.. Boat does look aligned on the trailer properly so not sure why the sides are off by a bit but oh well, must be from the shorelander factory. Which may be someone you call to ask about bunk placement on a lift?

Rear outside bunk measurement from keel to side of the board closest the keel. The outside board is approximately 6’ long.
View attachment 240240



Below are measurements for the front of the outside bunk stbd side and then rear of the middle bunk on stbd side.
View attachment 240241
Measurements for port side are:
Rear of middle bunk 10in
Front of outside bunk 17in


Inside bunk is approximately 8’ in length. Front of inside bunk port 10in and stbd 9.5in:
View attachment 240242

Not sure if this helps you in any way but good luck!

Thanks. Super helpful. Closer than I expected.